Introduction
Resetting the filter on a Samsung refrigerator is a simple process that ensures the filtration system continues to provide clean and fresh water. Regularly replacing the filter is essential to maintain the refrigerator’s optimal performance and to ensure the water dispensed is free from impurities. In this article, we will provide a step-by-step guide on how to reset the filter on a Samsung refrigerator.
Step 1: Identify the Filter Location
Materials used: Samsung refrigerator, replacement filter (if necessary)
The first step is to locate the filter inside your Samsung refrigerator. The filter is typically located in the upper right-hand corner of the refrigerator compartment or at the bottom of the refrigerator. Consult your refrigerator’s user manual or check the Samsung website for specific instructions on filter location for your model.
Step 2: Prepare for Filter Reset
Materials used: None
Before resetting the filter, make sure the refrigerator is turned on and the water supply is connected. It is also advisable to have a replacement filter on hand if the current filter needs to be replaced.
Step 3: Reset the Filter
Materials used: None
To reset the filter, locate the filter reset button on your Samsung refrigerator. The button is usually located near the filter or on the control panel. Press and hold the filter reset button for 3 to 5 seconds until the indicator light changes or goes off. This action will reset the filter status and ensure accurate monitoring of the filter’s lifespan.
Step 4: Replace the Filter (if necessary)
Materials used: Replacement filter, towel or cloth
If the filter needs to be replaced, follow these additional steps:
1. Turn off the water supply to the refrigerator.
2. Open the filter compartment by twisting or pulling the filter cover.
3. Remove the old filter by twisting it counterclockwise.
4. Take the new filter out of its packaging and remove any protective caps or seals.
5. Insert the new filter into the filter compartment and twist it clockwise until it locks into place.
6. Close the filter compartment by twisting or pushing the filter cover.
7. Turn on the water supply to the refrigerator.
8. Run water through the dispenser for a few minutes to flush out any air or impurities.
9. Use a towel or cloth to clean up any water spills or drips.
Conclusion
Resetting the filter on a Samsung refrigerator is a straightforward process that ensures the filtration system functions properly. By following the steps outlined in this article, you can easily reset the filter and maintain the quality of water dispensed by your refrigerator.
References
– samsung.com
– samsungsupport.com
