Introduction
Changing the filter on your Whirlpool refrigerator is an essential maintenance task that helps ensure clean and fresh-tasting water and ice. Regularly replacing the filter is necessary to remove impurities and contaminants from your water supply. In this article, we will guide you through the step-by-step process of changing the filter on your Whirlpool refrigerator.
Locating the Filter
Step 1: The first step is to locate the filter on your Whirlpool refrigerator. The filter is typically located inside the refrigerator compartment, either in the upper right corner or the lower grille. Refer to your refrigerator’s user manual for the exact location.
Preparing for Filter Replacement
Step 2: Before replacing the filter, it is important to turn off the ice maker. This will prevent any water flow while you are changing the filter.
Step 3: Next, open the refrigerator door and locate the filter compartment. Depending on your Whirlpool refrigerator model, you may need to remove a filter cover or housing to access the filter.
Removing the Old Filter
Step 4: Once you have accessed the filter compartment, carefully remove the old filter by turning it counterclockwise. Most Whirlpool filters have a twist-and-pull mechanism for easy removal. Be cautious as the old filter may still contain water.
Step 5: After removing the old filter, inspect it for any signs of damage or clogging. If the filter appears dirty or damaged, it is definitely time for a replacement.
Installing the New Filter
Step 6: Take the new filter out of its packaging. Remove any protective caps or seals from the filter.
Step 7: Align the new filter with the filter compartment and insert it into place. Rotate the filter clockwise until it locks into position. Make sure it is securely installed.
Resetting the Filter Indicator
Step 8: Some Whirlpool refrigerators have a filter indicator light that alerts you when it’s time to replace the filter. After installing the new filter, it is important to reset the filter indicator. Refer to your refrigerator’s user manual for instructions on how to reset the filter indicator.
Flushing the System
Step 9: Once the new filter is installed and the filter indicator is reset, it is recommended to flush the system. This will help remove any air or loose carbon particles from the new filter.
Step 10: To flush the system, dispense and discard several cups of water from the water dispenser. This will ensure that any impurities or carbon fines are flushed out.
Conclusion
Regularly changing the filter on your Whirlpool refrigerator is crucial for maintaining clean and fresh-tasting water and ice. By following the step-by-step process outlined in this article, you can easily replace the filter and ensure the continued performance of your refrigerator’s water filtration system.
References
– whirlpool.com
– manualslib.com
