Introduction
Reprogramming a Craftsman garage door opener may be necessary if you need to change the remote control or if the opener is not functioning properly. This article will guide you through the process of reprogramming your Craftsman garage door opener, ensuring that your opener is synced with your remote control and working correctly.
Step 1: Clearing the Opener’s Memory
Before reprogramming your Craftsman garage door opener, it is important to clear its memory to remove any existing codes. To do this, locate the “Learn” or “Smart” button on the opener, usually found near the antenna wire. Press and hold this button for approximately 10 seconds until the indicator light on the opener turns off. This will clear the memory of the opener.
Step 2: Programming the Remote Control
Once the opener’s memory is cleared, you can proceed with programming your remote control. Follow these steps:
1. Locate the “Learn” or “Smart” button: On the opener, find the “Learn” or “Smart” button, usually near the antenna wire.
2. Press the “Learn” or “Smart” button: Press and release the “Learn” or “Smart” button on the opener. The indicator light on the opener will turn on, indicating that it is ready to receive a new code.
3. Press the desired button on the remote control: Within 30 seconds of pressing the “Learn” or “Smart” button, press and hold the desired button on the remote control that you want to program. Hold the button until the indicator light on the opener blinks, indicating that the programming was successful.
4. Test the remote control: After programming the remote control, test it by pressing the programmed button. The garage door should respond by opening or closing.
Step 3: Reprogramming Additional Remote Controls
If you have multiple remote controls that you want to program to your Craftsman garage door opener, follow these steps:
1. Press the “Learn” or “Smart” button: Press and release the “Learn” or “Smart” button on the opener. The indicator light on the opener will turn on.
2. Press the desired button on the additional remote control: Within 30 seconds of pressing the “Learn” or “Smart” button, press and hold the desired button on the additional remote control that you want to program. Hold the button until the indicator light on the opener blinks, indicating that the programming was successful.
3. Test the additional remote control: After programming the additional remote control, test it by pressing the programmed button. The garage door should respond accordingly.
Conclusion
Reprogramming your Craftsman garage door opener is a straightforward process that involves clearing the opener’s memory and programming the remote control. By following the steps outlined in this article, you can ensure that your opener is synced with your remote control and functioning properly.
References
– craftsman.com
– hunker.com
– searspartsdirect.com
