Introduction
Reprogramming a Clicker garage door keypad is a straightforward process that allows you to change the access code and ensure the security of your garage. Whether you want to reset the code due to security concerns or simply need to update it, this article will guide you through the steps to reprogram your Clicker garage door keypad.
Step 1: Locate the Learn Button
The first step in reprogramming your Clicker garage door keypad is to locate the Learn button on your garage door opener. The Learn button is typically located on the back or side of the opener motor. It is usually a small, colored button that may be labeled as “Learn” or “Program.”
Step 2: Clear the Keypad’s Memory
Before you can reprogram the keypad, you need to clear its memory. To do this, press and hold the “Learn” button on the garage door opener for about 6 seconds. The Learn button’s LED light will turn on and then off, indicating that the memory has been cleared.
Step 3: Enter Programming Mode
After clearing the keypad’s memory, you need to enter programming mode. To do this, press and release the “Learn” button on the garage door opener. The Learn button’s LED light will start blinking, indicating that the opener is ready to learn a new code.
Step 4: Enter the New Code
Once you are in programming mode, enter the new code you want to use on the keypad. The code can be any combination of numbers, usually between 4 and 8 digits long. Make sure to choose a code that is easy for you to remember but difficult for others to guess.
Step 5: Program the Keypad
After entering the new code, press the “Enter” or “Send” button on the keypad. The Learn button’s LED light on the garage door opener will flash or turn off, indicating that the new code has been successfully programmed.
Step 6: Test the Keypad
To ensure that the reprogramming was successful, test the keypad by entering the new code and pressing the “Enter” or “Send” button. The garage door should open or close, depending on the command you entered. If the door doesn’t respond, repeat the reprogramming process from Step 1.
Conclusion
Reprogramming your Clicker garage door keypad is a simple process that involves locating the Learn button, clearing the keypad’s memory, entering programming mode, entering a new code, and testing the keypad. By following these steps, you can easily update the access code and enhance the security of your garage.
References
– Clicker: www.clickerproducts.com
– Chamberlain: www.chamberlain.com
