Introduction
Changing the water filter in a Whirlpool side-by-side refrigerator is a simple process that ensures clean and fresh-tasting water. Regularly replacing the water filter is important to maintain the quality of the water and the efficiency of the refrigerator. In this article, we will guide you through the step-by-step process of changing the water filter in your Whirlpool side-by-side refrigerator.
Step 1: Identify the Water Filter Location
Before starting the process, it is essential to locate the water filter in your Whirlpool side-by-side refrigerator. Typically, the water filter is located in the upper right-hand corner of the refrigerator compartment. Look for a small rectangular or cylindrical housing with a knob or button.
Step 2: Turn Off the Water Supply
To avoid any water leakage, it is important to turn off the water supply before changing the water filter. Locate the water shut-off valve behind the refrigerator or under the sink and turn it off. This will prevent any water from flowing into the refrigerator during the filter replacement process.
Step 3: Remove the Old Water Filter
Once the water supply is turned off, you can proceed to remove the old water filter. Depending on the model of your Whirlpool side-by-side refrigerator, the removal process may vary slightly. In most cases, you will need to twist the filter counterclockwise to unlock it from the housing. Once unlocked, gently pull the filter out of the housing.
Step 4: Prepare the New Water Filter
Before installing the new water filter, it is important to prepare it properly. Remove the protective cap from the new filter and locate the O-rings. If the new filter does not come with O-rings pre-installed, transfer the O-rings from the old filter to the new one. This will ensure a proper seal and prevent any leaks.
Step 5: Install the New Water Filter
With the new water filter prepared, you can now install it in your Whirlpool side-by-side refrigerator. Insert the filter into the housing and twist it clockwise to lock it in place. Make sure to tighten it firmly, but avoid over-tightening. The filter should be snug and secure.
Step 6: Turn On the Water Supply
After installing the new water filter, it is time to turn on the water supply. Locate the water shut-off valve and turn it back on. This will allow water to flow into the refrigerator and fill the new filter.
Step 7: Flush the Water Filter
To ensure the removal of any air or impurities from the new water filter, it is recommended to flush it before using the water. Run several gallons of water through the dispenser to clear out any initial debris or carbon fines.
Step 8: Reset the Water Filter Indicator
Many Whirlpool side-by-side refrigerators have a water filter indicator that needs to be reset after changing the filter. Consult your refrigerator’s manual to determine the specific steps to reset the indicator. This step is important to ensure accurate monitoring of the filter’s lifespan.
Conclusion
Changing the water filter in your Whirlpool side-by-side refrigerator is a straightforward process that can be done by following a few simple steps. Regularly replacing the water filter will help maintain the quality of your drinking water and ensure the efficient operation of your refrigerator.
References
– whirlpool.com
– manualslib.com
