Introduction
Resetting the filter light on a Whirlpool refrigerator is a simple process that ensures your appliance continues to provide clean and fresh-tasting water. The filter light serves as a reminder to replace the water filter regularly, typically every six months. In this article, we will guide you through the steps to reset the filter light on your Whirlpool refrigerator, ensuring you can enjoy clean and filtered water without any interruptions.
Locating the Filter Light
Before we proceed with resetting the filter light, it is important to locate it on your Whirlpool refrigerator. The filter light is usually located on the control panel of the refrigerator, either on the dispenser or inside the refrigerator compartment. Look for a small indicator light that says “Filter” or “Replace Filter.”
Resetting the Filter Light
Once you have located the filter light, follow these steps to reset it:
Step 1: Press and hold the “Filter Reset” or “Reset” button for 3-5 seconds. This button is often located next to the filter light on the control panel.
Step 2: Wait for the filter light to blink or turn off. This indicates that the filter light has been successfully reset.
Step 3: Release the “Filter Reset” or “Reset” button.
Verifying the Reset
To ensure that the filter light has been properly reset, you can perform a quick check:
Step 1: Dispense water from the refrigerator’s water dispenser.
Step 2: If the water flows smoothly without any warning lights or messages, it indicates that the filter light has been successfully reset.
If the filter light continues to stay on or blink, repeat the reset process again. In some cases, it may take a couple of attempts to reset the light successfully.
Replacing the Water Filter
Resetting the filter light is only a temporary solution. It is essential to replace the water filter regularly to ensure the quality and taste of your water. Follow these steps to replace the water filter in your Whirlpool refrigerator:
Step 1: Locate the water filter compartment. It is usually located inside the refrigerator compartment, near the top or bottom.
Step 2: Open the filter compartment door. Depending on the model, you may need to twist, push, or pull to open the door.
Step 3: Remove the old water filter by twisting it counterclockwise. Be cautious as some water may spill out during this process.
Step 4: Prepare the new water filter by removing the protective cap and any packaging.
Step 5: Insert the new water filter into the filter compartment and twist it clockwise until it locks into place.
Step 6: Close the filter compartment door.
Conclusion
Resetting the filter light on your Whirlpool refrigerator is a straightforward process that ensures you can enjoy clean and filtered water. By following the steps outlined in this article, you can easily reset the filter light and replace the water filter when necessary. Remember to reset the filter light regularly to maintain the optimal performance of your Whirlpool refrigerator.
References
– whirlpool.com
– manualslib.com
