How to install doona car seat?

How to install doona car seat?


Installing a Doona car seat is an essential step in ensuring the safety and comfort of your child while traveling. This article will provide a step-by-step guide on how to install a Doona car seat properly. By following these instructions, you can have peace of mind knowing that your child is secure during car journeys.

Gather the Materials

Before starting the installation process, it is important to gather all the necessary materials. These may include:

Doona car seat: Make sure you have the Doona car seat ready for installation.

Car owner’s manual: Refer to the car owner’s manual to understand the specific instructions and requirements for installing a car seat in your vehicle.

Seatbelt or LATCH system: Depending on your car’s make and model, you will need either a seatbelt or the LATCH (Lower Anchors and Tethers for Children) system to secure the car seat.

Choose the Correct Position

The next step is to choose the correct position for installing the Doona car seat. The safest place for a car seat is in the back seat, preferably in the middle. This position provides the most protection in the event of a collision.

Install the Base

The Doona car seat comes with a base that needs to be installed first. Follow these steps to install the base correctly:

1. Place the base on the back seat of your car in the desired position.

2. If you are using the seatbelt to secure the base, thread the seatbelt through the designated belt path on the base. Make sure the seatbelt is not twisted.

3. Buckle the seatbelt and pull it tight to secure the base. Ensure that the base is level and does not move more than an inch in any direction.

4. If your car is equipped with the LATCH system, locate the lower anchors in your vehicle. Attach the LATCH connectors on the base to the lower anchors, following the car owner’s manual for specific instructions.

5. Push down on the base to ensure a secure fit. The base should not move more than an inch in any direction.

Attach the Doona Car Seat

Once the base is securely installed, you can attach the Doona car seat to it. Follow these steps:

1. Place the Doona car seat onto the base, aligning the connectors on the car seat with the corresponding slots on the base.

2. Push the car seat down firmly until you hear a click, indicating that it is securely attached to the base.

3. Check that the car seat is properly locked in place by gently pulling up on it. It should not detach from the base.

Adjust the Harness

After attaching the car seat, it is important to adjust the harness to ensure a proper fit for your child. Follow these steps:

1. Loosen the harness straps by pressing the release button on the front of the car seat.

2. Place your child in the car seat and buckle the harness straps.

3. Adjust the harness straps so that they are snug but not too tight. The straps should be at or slightly above your child’s shoulders.

4. Make sure the chest clip is positioned at armpit level.


Installing a Doona car seat correctly is crucial for the safety of your child while traveling. By following the step-by-step guide provided in this article, you can ensure that the car seat is securely installed and properly adjusted. Remember to always refer to the car owner’s manual for specific instructions and guidelines.


– car manufacturer’s website (e.g.,