How to program craftsman garage door opener?

How to program craftsman garage door opener?

Introduction

Programming a Craftsman garage door opener is a relatively simple process that can be done by following a few easy steps. This article will guide you through the process of programming your Craftsman garage door opener, ensuring that you can operate it smoothly and securely.

Step 1: Clearing Existing Codes

Before programming a new code into your Craftsman garage door opener, it is essential to clear any existing codes. This step ensures that only authorized individuals can access your garage. To clear the existing codes, locate the “Learn” button on the back of your opener motor unit. Press and hold this button for about 10 seconds until the indicator light turns off. This action erases all previously programmed codes.

Step 2: Programming the Remote Control

To program the remote control for your Craftsman garage door opener, follow these steps:

Materials needed: Craftsman remote control, ladder (if necessary)

  1. Locate the “Learn” button on the back of the opener motor unit.
  2. Press and release the “Learn” button. The indicator light will turn on.
  3. Within 30 seconds, press and hold the button on your remote control that you wish to program.
  4. Continue holding the remote control button until the opener lights flash or you hear two clicks. This indicates that the programming was successful.
  5. Test the remote control by pressing the programmed button to ensure that the garage door opens or closes as desired.

Repeat these steps for each remote control you want to program.

Step 3: Programming the Wireless Keypad

If you have a wireless keypad for your Craftsman garage door opener, you can program it using the following steps:

Materials needed: Craftsman wireless keypad, ladder (if necessary)

  1. Locate the “Learn” button on the back of the opener motor unit.
  2. Press and release the “Learn” button. The indicator light will turn on.
  3. Within 30 seconds, enter a four-digit PIN of your choice on the wireless keypad.
  4. Press and hold the “Enter” button on the keypad until the opener lights flash or you hear two clicks. This indicates that the programming was successful.
  5. Test the wireless keypad by entering the programmed PIN and pressing the “Enter” button to ensure that the garage door opens or closes as desired.

Step 4: Programming the Wall Control Panel

To program the wall control panel for your Craftsman garage door opener, follow these steps:

Materials needed: Craftsman wall control panel

  1. Locate the “Learn” button on the back of the opener motor unit.
  2. Press and release the “Learn” button. The indicator light will turn on.
  3. Within 30 seconds, press and hold the light button on the wall control panel.
  4. Continue holding the light button until the opener lights flash or you hear two clicks. This indicates that the programming was successful.
  5. Test the wall control panel by pressing the programmed light button to ensure that the garage door opens or closes as desired.

Conclusion

Programming your Craftsman garage door opener is a straightforward process that can be done by following a few simple steps. By clearing any existing codes and programming the remote control, wireless keypad, and wall control panel, you can ensure secure and convenient access to your garage.

References

– craftsman.com
– sears.com